Beer Forum

Posted: **Tue May 18, 2010 4:32 pm**

Where can I get the CO2 splitter needed for the beer gun? I have the beer gun and the accessory pack, and this will be the last step.......

Posted: **Tue May 18, 2010 4:37 pm**

joshwilfong wrote:Where can I get the CO2 splitter needed for the beer gun? I have the beer gun and the accessory pack, and this will be the last step.......

you could try this.

http://www.terrencetheblack.com/forum/v ... =5&t=15542

Posted: **Tue May 18, 2010 5:01 pm**

what is the role of the regulator inlet nuts that came with the accessory pack? could these take the role of the y adapter if not are there any hardware stores that may sell the y adapter or must I resort to the internet?

Posted: **Wed May 19, 2010 6:42 am**

If you're talking about the brass flare adapter, I believe you need a wye adapter on your regulator to use that.

I've never really understood the accessory kit. It seems like a few random things thrown together.

Posted: **Thu May 20, 2010 12:49 pm**

There is an Accessory Kit "1" and "2".

Beer Gun Accessory Kit #1
This accessory kit provides almost everything needed to get your BeerGun up and running: a liquid ball-lock disconnect, a 5' length of hose for your CO2 line with 1/4" stainless flare connectors on each end, one stainless 1/4" disconnect (for the 10' beer hose that comes with the BeerGun), and a brass 1/4" NPT X 1/4" flare adapter for connecting to the CO2 valve on the BeerGun. Read below for information about Beer Gun Accessory Kit #2.

Beer Gun Accessory Kit #2
Because most people do not have regulators with dual MFL outlets as shown in the instructions for the BeerGun provided by Blichmann Engineering, a second group of hardware items are necessary to make the BeerGun operational. This second group of items includes an MFL gas disconnect, an MFL tee, and three FFL-to-hose-barb swivel nuts. It is assembled with clamps.

I got kit 1 and did not find it real useful. Should have got kit 2.

The MFL tee is generic and not needed if you put a T and a 1/4" ball valve and hose barb on your regulator gas out.

Charlie

Posted: **Thu May 20, 2010 1:20 pm**

I have a tee after my c02 regulator. One end goes to a ball lock disconnect (I have a tank I use just for transfers and other stuff, if I had a single tank this would go to a manifold or secondary regulators or whatever), the other end goes to a female plastic gas line disconnect (B3 sells these, I think NB does too). Then I have a few of the plastic male disconnects so I can easily swap things in and out. So far I have a counter pressure filler, a line to pressurize a better bottle for transfer and a Tasty style device for co2 purging bottles set up with a male. Takes 1 second to hook any of these up.

Beer Forum

Mysterious beer gun CO2 adapter

Mysterious beer gun CO2 adapter

Re: Mysterious beer gun CO2 adapter

Re: Mysterious beer gun CO2 adapter

Re: Mysterious beer gun CO2 adapter

Re: Mysterious beer gun CO2 adapter

Re: Mysterious beer gun CO2 adapter