Thu Jun 24, 2010 7:25 am
me no likey the system running off the sensor on the outlet - I think it will give you terrible control and make the system prone to horrible overshoot.
I think the best place to drive the system from would be at the point where your wort enters the mash tun - or considering that would require you to re-do some physical wiring - the exit of your Heat-ex with an understanding that there will be heat loss between there and the tun.
With the unit driving from the outlet... you are shoving in heat at the top of the tun, but the temp at the outlet wont change enough to turn off your heat till all the mash bed has changed all the way... and by the time the bottom bit has changed, the top of the mash bed is already too hot and your HLT has been pushed even higher... and that heat will go into the tun too.