Brewstand

[swifty]

Here is my mostly finished brewstand.....this was my water test day

[swifty]

[swifty]

New paint job of high temp engine paint, Ill see how well it holds up next brew day

[Landshark]

Do you have a picture of the controller box wiring available? I'm looking for a few ideas and am looking to steal all the good ones and keep my brain activity in it's idle state.

Thanks!

-Shark

[ApresSkiBrewer]

Lookin' sharp!

Oh, btw. I hate you.

[swifty]

Wiring looks like this in the inside, I (my buddy) just followed the Brutus 10 wiring diagram.....Im gonna change my probes from coming out of the bottom left side of the control panel. My first brew, I burned one of the probes when it hit against the outside of the frame, I bought 10ft probes and am going to run it down the steel tube connected to the control panel so my lines will be coming from the bottom up, and not across where the flame is.



wiring could be a little cleaner looking, but it works

[Landshark]

Thanks! I was attempting to understand if the main power source needed to go to a bus before being fed out to the switches and controllers.

-Shark

[Whitebeard_Brewer]

Landshark, that is exactly how I did mine....with buses....one for hot, neutral, and ground, then everything is powered off of those. No wire nuts were used in my box.