I forgot to add the mash hop (just being hasty, no valid excuse) until I was ramping up to mash-out temp. I added it at that time. I have a RIMS system, so it took me probably 15 minutes to ramp up to 168F and then I recirc'd for another 10 minutes before beginning the sparge, so the hops were in there for a bit, but not the entire mash. What do you think?
Second, I missed Tasty's note that the Cascase addition being through a hopback and if replacing it with a zero minute addition, it should be cut in half so I had a BIG charge of Cascade at flameout. I'm not worried as I figure it will just add more aroma, but again, any thoughts?
Finally, I have to split my 11 gallon batch between 2 fermenters. Should I put a full amount of dry hop per the recipe in each fermenter, or should I split the dry hop and add half of what the recipe calls for to each fermenter? I brewed this 2 years ago, and it turned out great (won 2nd BOS at Wisconsin State Fair), but I didn't take good notes and don't know what I did then. I think I split it, but was wondering what everyone else thinks. Also, does he add all the dry hop at once, or in stages?

BN Army // 13th Mountain Division 



